Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9
TX-Band
Press the left [BAND SEL] (VHF) or the right [BAND SEL]
(UHF) to select. "PTT" on the display shows which band
(VHF or UHF) is currently selected as the transmit (TX)
band. You can use the TX band to transmit signals or to
control the transceiver.
Control Band
Press [CONT SEL] to select. On the display "Ctrl" appears
to show which band (VHF or UHF) is currently selected as
the Control band. Use this function when you want to
control the band that is not currently used for TX. After
selecting the Control band, you cannot control the TX
band.
PWRPWR
VOL SQL
CALLCALL
PWRPWR
VOL SQL
CALLCALL
BUTTON FUNCTION DISPLAY
The lower portion of the display has labels that indicate the
current function of each of the 4 front panel buttons. The
italic font is used to show these 4 buttons in the description
of each operation step. After pressing
[F]
or
[F]
(1 s)
,
pressing
[F]
again or waiting for 10 seconds restores the
basic state.
Note:
◆
When selecting Program Memory mode, you will also see different
labels. See "Programmable Memory mode" {page 8}.
◆
You can also select different combinations of button labels. Refer to
"CHANGING MULTI-FUNCTION BUTTON LABELS" {page 66}.
◆
After pressing [F] or [F] (1 s), press the appropriate key within
approximately 10 seconds, or the Basic State display will be restored.
Labels after
Pressing
[F] (1 s)
Basic State
Display Labels
Labels after
Pressing
[F]
s
s
s