Kenwood TM-V7E Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
72
The following types of front panel key functions can be
assigned:
The following types of front panel key functions cannot be
assigned:
The front panel key will still function normally after
"copying" its function to a Programmable Function key.
To restore the default functions shown in the table above,
do a Full Reset {page 35}.
Note:
If the LOCK switch located on the rear of the microphone is ON,
you cannot re-program the Programmable Function keys.
Pressing the PTT switch in step 2 assigns the VFO/MR Switch
function.
CONFIGURING PROGRAM FUNCTION KEYS
The Programmable Function keys are [PF], [MR], [VFO],
and [CALL] located on the face of the microphone. If you
prefer, you can change the default functions assigned to
these keys.
To assign a front panel key function:
1 Press one of the following key combinations depending
on which key you want to re-program:
Mic [PF]+ POWER ON ("PF 1" appears)
Mic [MR]+ POWER ON ("PF 2" appears)
Mic [VFO]+ POWER ON ("PF 3" appears)
Mic [CALL]+ POWER ON ("PF 4" appears)
2 Press the key or key combination on the front panel that
you want to assign.
[PF]
[MR]
[VFO]
[CALL]
Programmable Function Key
Default Function
TX Band Select
Memory Recall
VFO Select
Call Channel Select
[F]
(1 s)
, [KEY]
[F] (1 s)
Tuning control
[KEY]
[KEY]+ POWER ON
[F]
+ Mic [KEY]
VOL control
[F],
[KEY]
[F]
PWR switch
SQL control
[KEY] (1 s)