Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
2
MOBILE INSTALLATION
Install the transceiver in a safe, convenient position inside
your vehicle that minimizes danger to your passengers and
yourself while the vehicle is in motion. For example,
consider installing the transceiver under the dash in front of
the passenger seat so that knees or legs will not strike the
radio during sudden braking of your vehicle. Try to pick a
well-ventilated location that is shielded from direct sunlight.
■ Installation Example
Use the supplied mounting bracket to install the
transceiver inside your vehicle. To enjoy the best
viewing angle, you can position the transceiver in the
bracket in a number of ways as shown below.
■ Installation Steps
1 Install the mounting bracket in the vehicle using the
supplied flat washers and self-tapping screws.
There are 4 washers and 4 screws supplied.
• The bracket can be mounted with the bracket opening
for the transceiver facing down for underdash
mounting, or with the opening facing up.
• The bracket must be installed so that the 4 screw
holes on the edge of each bracket side are facing
forward.
2 Position the transceiver, then insert and tighten the
supplied hexagon SEMS screws and washers.
There are 2 screws and 2 washers supplied for each
side of the bracket.
• Double check that all hardware is tightened to prevent
vehicle vibration from loosening the bracket or
transceiver.
PREPARATION FOR MOBILE AND FIXED STATION OPERATION
Flat washer
Self-tapping
screw
K
E
N
W
O
O
D
F
M
D
U
A
L
B
A
N
D
E
R
T
M
-
V
7
SEMS screw