Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
6
ACCESSORY CONNECTIONS
■ External Speakers
If you plan to use external speakers, choose speakers
with an impedance of 8 Ω. The external speaker jacks
accept a 3.5 mm (1/8") diameter mono (2-conductor)
plug. Recommended speakers include the SP-50B and
SP-41.
■ Microphone
To communicate in the voice modes, plug a 600 Ω
microphone equipped with an 8-pin modular connector
into the modular socket on the front panel of the
transceiver. Press firmly on the plug until the locking tab
clicks.
PACKET EQUIPMENT CONNECTIONS
If you intend to use this transceiver for Packet operation,
you will need the following equipment.
• Personal computer with communications software
• Terminal Node Controller (TNC)
• TNC power supply
• RS-232C cable
• 6-pin mini DIN plug (optional PG-5A)
For the DATA connector pins, refer to “PACKET
OPERATION” {page 79}.
Note:
◆
Do not share a single power supply between the transceiver and the
TNC.
◆
Keep as wide a separation between the transceiver and computer as
practical to reduce noise-pickup by the transceiver.
◆
One end of the optional PG-5A cable has not been connectorized.
Attach the appropriate connector that mates with the TNC connector.
K
E
N
W
O
O
D
F
M
D
U
A
L
B
A
N
D
E
R
T
M
-
V
7
KENWOOD
FM DUAL BANDER TM-000
KENWOODKENWOOD
FM DUAL FM DUAL
TNC power
supply
Transceiver
power supply
RS-232C cable
TNC
PG-5A cable
TM-V7