Kenwood TM-V7E Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
62
PWRPWR
VOL SQL
CALLCALL
AUTOMATIC BAND CHANGE (A.B.C.)
A.B.C. will temporarily switch the RX only band to the TX
band immediately after a signal is received on the RX only
band. This function allows you to reply to a caller without
manually selecting the correct band.
Press
[F]
, [MNU] to toggle the function ON or OFF.
"A.B.C." appears when the function is ON.
Pressing [BAND SEL] or Mic [PTT] also cancels A.B.C.
The original TX band is restored 2 seconds after the signal
drops out.
Note:
You cannot use A.B.C. when in Single-band mode. After activating
A.B.C., changing from Dual-band mode to Single-band mode
deactivates A.B.C. Switching back to Dual-band mode re-activates
A.B.C.
After activating A.B.C., starting Visual Scan deactivates A.B.C.
Canceling Visual Scan re-activates A.B.C.
ADVANCED INTERCEPT POINT (AIP)
AIP helps eliminate interference and reduce audio
distortion caused by intermodulation. This problem is often
apparent in urban areas when the RX band is extremely
crowded.
1 Select the desired band.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 9 (AIP).
"VHF AIP" or "UHF AIP" appears depending on which
band you selected.
4 Press
[SET]
to toggle the function ON or OFF (default).
5 Press [MNU] again to exit Menu mode.
Note: While using VHF/VHF RX or UHF/UHF RX, switching the AIP
function ON or OFF on the main band also activates or deactivates AIP
on the sub band.
1