Kenwood TM-V7E Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
30
STORING DATA IN SIMPLEX CHANNELS
1 Select the desired band.
2 Select the desired frequency and related data (Tone,
CTCSS, DTSS, etc.) using VFO mode, Memory Recall
{page 31}, or the Call channel {page 33}.
3 Press
[F]
.
A memory channel number and an arrow appear.
The arrow shows whether the current memory channel
contains data ("
ss
ss
s") or not ("
uu
uu
u").
4 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the desired memory channel.
5 Press [MR].
The selected frequency and related data are stored in the
memory channel. The transmit frequency from a split
memory channel or split Call channel is not stored.
If the memory channel selected in the previous step
already contained data, the new data overwrites the
previous data.
STORING DATA IN SPLIT CHANNELS
1 To select the desired receive frequency, related data
and memory channel, use steps 1 to 4 (not 5) given for
Simplex Memory Channels.
2 Press [MR] (1 s).
•" ± " appears.
3 Select the desired transmit frequency.
4 Press [MR].
The selected transmit frequency is stored in the memory
channel.
Note:
If you select an offset direction in step 1, you can also press [REV] in
step 3 to select a transmit frequency. The transmit frequency
separated by the current offset frequency will be stored in the
memory channel.
In step 2 you cannot use Mic [MR], or Mic [PF] programmed with
Memory Recall.
Transmit Offset status and Reverse status are not stored in a split
memory channel.