Kenwood TM-V7E Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
73
To assign a function unavailable using the front panel keys:
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 16 (Microphone).
3 Press
[
ss
ss
s
]
, then select Item No. 2 (PF 1) to No. 5 (PF 4).
4 Press
[SET]
to select the desired function.
Each time you press
[SET]
, the selection changes as
shown below:
User Setting Monitor Enter Voice PWR switch
(PF 1 only) 1750 Hz Tone (TM-V7E only)
5 Press [MNU] again to exit Menu mode.
User Setting:
Selects the front panel key function you assigned
{page 72}.
Monitor:
Makes the squelch open and allows you to monitor activity
on the current frequency. This function is useful when
adjusting the volume or when receiving weak signals.
Pressing the re-programmed Mic key toggles Monitor ON or
OFF.
Scan will not function if Monitor is ON (squelch open).
Enter:
Allows you to enter digits from the MC-53DM microphone.
Refer to "KEYPAD DIRECT ENTRY" {page 74}.
Voice:
Activates or deactivates the function that announces the
current Control band frequency using beeps of different
frequencies. Press any key to stop beeps.
PWR switch:
Turns the transceiver ON or OFF. This function can be
assigned only to PF 1.
1750 Hz Tone (TM-V7E only):
Activates the Tone function and transmits a 1750 Hz tone
while you are holding down the re-programmed Mic key.
You need not press Mic [PTT].
You can also use Transmit Hold to continuously send a
1750 Hz tone for 2 seconds after releasing the
re-programmed Mic key. To activate this function, access item
No. 3 (1750 Hz Timer) in Menu No. 5 (Repeater).
PWRPWR
VOL SQL
CALLCALL
PWRPWR
VOL SQL
CALLCALL
1
2