Kenwood TM-V71E Stereo System User Manual


 
57
n Transmitting Stored DTMF Codes
1 Press and hold the microphone [PTT].
2 While transmitting, press the Tuning control.
The last called DTMF Memory channel name and number appear on the display.
If no name has been saved for the channel, the DTMF code appears.
3 While still transmitting, rotate the Tuning control to select your desired
DTMF Memory channel, then press the Tuning control to set the channel.
Additionally, you can press a DTMF key corresponding to your desired channel
([0] ~ [9]) to select the channel and begin transmission.
The stored DTMF code scrolls across the display and is transmitted.
The code will be transmitted even if you release
[PTT] before the entire code has
scrolled across the display.
If no DTMF code is stored in the selected channel, the frequency display is
restored.
n Selecting a Transmit Speed
Some repeaters may not respond correctly if a DTMF code is transmitted at
fast speed. If this happens, change the DTMF code transmission speed from
FAST (default) to SLOW.
1 Enter Menu mode and access Menu 302 (DT.SPD) {page 20}.
2 Set the speed to FAST or SLOW.