Kenwood TM-V71E Stereo System User Manual


 
4
3 Connect the DC power cable to the transceiver.
Press the connectors firmly together until the locking tab clicks.
Note: For your transceiver to fully exhibit its performance capabilities, we recommend using
an optional PS-33 (20.5 A, 25% duty cycle) power supply.
n Replacing Fuses
If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to
blow, disconnect the power cable and contact your authorized Kenwood
dealer or an authorized Kenwood service center for assistance.
Fuse Location Fuse Current Rating
Transceiver
(located on the DC connector)
15 A
Supplied DC power cable 20A
Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.
Black (—)
cable
Red (+)
cable
DC power cable
Fuse holder
(K, M4 types)
Fuse holder
(E type)
Fuse holder (E type)
Fuse holder
(K, M4 types)
Regulated DC
power supply
Fuse holder (E type) Fuse holder (K, M4 types)
Fuse
Fuse holder
Fuse holder
Fuse