Kenwood TM-V71E Stereo System User Manual


 
33
STORINg SIMPLEX AND STANDARD REPEATER FREquENCIES
1 Press [VFO] to enter VFO mode.
2 Rotate the Tuning control to select your desired frequency.
Additionally, you can press the microphone [UP]/[DWN] keys to select a frequency.
3 Set up any additional data desired for the frequency.
Offset direction, Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS frequency,
DCS ON/OFF, DCS code, etc.
4 Press [F].
A memory channel number appears.
5 Rotate the Tuning control to select your desired channel number.
Additionally, you can press the microphone [UP]/[DWN] keys to select a channel.
6 Press [MR] to store the data in the selected Memory channel.
Note: If you store the data in a Memory channel that already has data stored in it, the old data will
be cleared and the new data will be stored.
n Call Channel Memory (Simplex)
The Call channel can be used to store any frequency and related data that you
will recall often. You may want to dedicate the Call channel as an emergency
channel within your group.
To store a simplex frequency and related data as the Call channel instead of in
a Memory channel, after step 4 (above), press [CALL].
Note: Storing new data in the Call channel will clear the old data. (The Call channel itself
cannot be cleared, but data can be replaced with new data.)
STORINg ODD-SPLIT REPEATER FREquENCIES
Some repeaters use a receive and transmit frequency pair with a non-standard
offset. To access those repeaters, store two separate frequencies in a memory
channel. You can then operate on those repeaters without changing the offset
frequency you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of “STORING SIMPLEX
AND STANDARD REPEATER FREQUENCIES”, above.
2 Press [VFO] to enter VFO mode.
3 Rotate the Tuning control to select your desired transmit frequency.
Additionally, you can press the microphone [UP]/[DWN] keys to select a frequency.