Filter
Top Products
51
CTCSS FREQUENCY ID
This function scans through all CTCSS frequencies to identify the incoming
CTCSS frequency on a received signal. You may find this useful when you
cannot recall the CTCSS frequency that the other persons in your group are
using.
1 Press [TONE] 2 times to activate the CTCSS function.
• The icon appears on the display when the CTCSS function is ON.
• Each press of
[TONE] changes the selection as follows:
Tone (T) –> CTCSS (CT) –> DCS (DCS) –> Off (no display).
2 Press [F], [TONE] (1s).
• The icon blinks and “SCAN” appears on the display.
• Scan starts when a signal is received.
• To reverse the scan direction, turn the Tuning control clockwise (upward scan) or
counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].
• To quit the scan, press
[F] (ESC).
• When a CTCSS frequency is identified, the identified frequency appears on the
display and blinks.
3 Press the Tuning control to program the identified frequency in place of the
currently set CTCSS frequency.
• The CTCSS function will remain ON. To cancel CTCSS, press [TONE] until CT no
longer appears on the display.
• Press
[F] (ESC) if you do not want to program the identified frequency.
• Rotate the
Tuning control while an identified frequency is blinking, to resume
scanning.