Kenwood TM-V71E Stereo System User Manual


 
53
You can also select a DCS code by using the microphone:
1 Select your desired band.
2 Press [TONE] 3 times to activate the DCS function.
The icon appears on the display when the DCS function is ON.
Each press of
[TONE] changes the selection as follows:
Tone (T) –> CTCSS (CT) –> DCS (DCS) –> Off (no display).
3 Press [F], [TONE].
The current DCS code appears on the display and blinks.
4 Press the key programmed as [ENTER].
5 Enter your desired DCS code using the microphone keypad.
Refer to the table below for DCS codes.
6 Press [ENTER] again to complete the setting.
DCS Code
023 025 026 031 032 036 043 047
051 053 054 065 071 072 073 074
114 115 116 122 125 131 132 134
143 145 152 155 156 162 165 172
174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265
266 271 274 306 311 315 325 331
332 343 346 351 356 364 365 371
411 412 413 423 431 432 445 446
452 454 455 462 624 465 466 503
506 516 523 565 532 546 565 606
612 624 627 631 632 654 662 664
703 712 723 731 732 734 743 754