Kenwood KDC-X996 Stereo Receiver User Manual


  Open as PDF
of 45
 
53
|
KDC-X996/ KDC-BT952HD
English
|
54
DSP Setup
Resetting of DTA Settings
You can reset the DTA-compensated values to the
factory settings.
1
Select the source
Pressing the [SRC] button repeatedly switches
source.
Select a source other than “STANDBY”.
✍ SRC Select mode 2: Press the [SRC] button and
then turn the [VOL] knob. To determine the
selected source, press the [VOL] knob.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Enter Reset DTA Setting mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup” > “DTA Settings” > “Reset
DTA Setting”.
4
Reset the DTA settings
Turn the [VOL] knob to select “YES”, and then
press the [VOL] knob.
Audio Preset Memory
Registering the value setup by Sound Control.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Manual Equalizer Control (page 47)
- Car Type Selection (page 49)
- Speaker Setting (page 49)
- X’OverSetting(page50)
- ListeningPositionSelection(page51)
- ListeningPositionFineAdjustments(page51)
- Channel Level Fine Adjustments (page 52)
2
Enter Audio preset memory mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup” > “Preset” > “Memory”.
3
Select the number to put in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select a preset number.
4
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “YES”.
“Memory Completed” is displayed.
5
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• Register2patternsofAudioPresetMemory.
• Presetnumber“1”:
When you press the Reset, all the sources will be the
setting value which is registered.
• Presetnumber“1”and“2”:
The memory cannot be erased by the Reset button.
• ThisfunctioncannotberegisteredwhentheiPod
Equalizer set in <Preset Equalizer curve Select> (page 46).
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 53).
1
Select the source
Pressing the [SRC] button repeatedly switches
source.
Select a source other than “STANDBY”.
✍ SRC Select mode 2: Press the [SRC] button and
then turn the [VOL] knob. To determine the
selected source, press the [VOL] knob.
2
Enter Audio preset recall mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup” > “Preset” > “Recall”.
3
Select the number to recall in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select preset number.
4
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “YES”.
“Recall Completed” is displayed.
5
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• The“User”of<Preset Equalizer curve Select> (page 46) is
changed to the value which was recalled.
• TheEqualizercurveischangedtothevaluewhichwas
recalled by the selected source.
 previous next