Filter
Top Products
Audio Adjustments
Using no fading output
When the non fading output setting is on, the
audio signal does not pass through this unit’s
low pass filter (for the subwoofer), but is output
through the RCA output.
1 Press
OPEN to open the front panel.
2 Press AUDIO to select non fading output
on/off mode.
When the subwoofer controller setting is
S.W
Control:EXT, you can select non fading output
on/off mode. Press AUDIO until NonFad ON
appears in the display.
3 Press 5to turn non fading output on.
NonFad ON appears in the display. non fading
output is now on.
• You can turn off non fading output by pressing
∞.
Adjusting non fading output level
When the non fading output is on, you can
adjust the level of non fading output.
1 Press OPEN to open the front panel.
2 Press
AUDIO to select non fading output
setting mode.
Press
AUDIO until NonFad 0 appears in the dis-
play.
3 Press 5 or ∞ to adjust the output level of
the non fading.
Each press of 5 or ∞ increases or decreases
the level of the non fading. +6 ––6 is displayed
as the level is increased or decreased.
Press 5 or ∞ until you see the desired value
displayed.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play from
the front or rear speakers, switch the HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from the
front and rear speakers.
1 Press
OPEN to open the front panel.
2 Press AUDIO to select HPF.
Press
AUDIO until HPF appears in the display.
3 Press 5to turn high pass filter on.
HPF 80 Hz appears in the display. High pass
filter is now on.
• To turn high pass filter off, press ∞.
4 Press 2 or 3to select a high pass filter
range.
Press 2 or 3 until the desired cut-off frequency
appears in the display.
50—80—125 (Hz)
• Only frequencies higher than those in the
selected range are output from the front or rear
speakers.
Note
• If you switch the SFEQ mode, the H.P.F. func-
tion is automatically switched off. By switch-
ing the H.P.F. function on after selecting the
SFEQ mode, you can combine H.P.F. function
with SFEQ function.
En
42
07
Section