Filter
Top Products
Audio Adjustments
Fine adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (EQ-Low/EQ-Mid/EQ-High).
1 Press
OPEN to open the front panel.
2 Press AUDIO and hold until frequency and
the Q factor (e.g., F 80 Q 1W) appears in the
display.
3 Press AUDIO to select the desired band for
adjustment.
low—mid—high
4 Press 2 or 3 to select the frequency.
Press 2 or 3 until the desired frequency
appears in the display.
low : 40—80—100—160 (Hz)
mid : 200—500—1 k—2 k (Hz)
high : 3.15 k—8 k—10 k—12.5 k (Hz)
5 Press 5/∞to select the desired Q factor.
Press 5 or ∞ until the desired Q factor appears
in the display.
2 N—1 N—1 W—2 W
Note
• If you make adjustments when a curve other
than CUSTOM2 is selected, CUSTOM1 curve
is updated.
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
• In FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press
OPEN to open the front panel.
2 Press AUDIO to select Bass.
Press
AUDIO until Bass appears in the display.
3 Press 2 or 3 to select the frequency.
Press 2 or 3 until the desired frequency
appears in the display.
40—63—100—160 (Hz)
4 Press 5 or ∞ to adjust the bass level.
Each press of 5 or ∞ increases or decreases
the bass level. +6 ––6 is displayed as the level is
increased or decreased.
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
• In FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Treble.
Press AUDIO until Treble appears in the display.
3 Press 2 or 3 to select the frequency.
Press 2 or 3 until the desired frequency
appears in the display.
2.5k—4k—6.3k—10k (Hz)
4 Press 5 or ∞ to adjust the treble level.
En
40
07
Section
Level (dB)
Center frequency
Frequency (Hz)
Q=2N
Q=2W