JVC RX-772VBK Stereo Receiver User Manual


 
Page 37
FUNCTIONS:
This remote control system allows you to use four functions listed below.
Note:
Refer also to the manuals supplied with your video components.
77
77
7 Remote Control of the TV through the Remote Sensor on the Receiver
You can control the TV through the remote sensor on the receiver using this remote control.
For details, see page 39.
Note:
Aim the remote control directly at the remote sensor on the receiver when operating the TV. (However, to
operate the VCR, always aim the remote control directly at the remote sensor on the VCR.)
77
77
7 One-Touch Video Play
Simply by inserting a video cassette without its safety tab into the VCR, you can enjoy the video playback
without setting other switches manually.
The receiver automatically turns on and changes the source to “VCR.”
The TV automatically turns on and changes the input mode to the position you can view the VCR playback.
When you insert a video cassette with its safety tab, press the play (
33
33
3) button on the VCR or on the remote
control. So, you can get the same result.
Note:
When you connect an S-VHS VCR as described on page 36, you cannot see the on-screen displays (such as
Visual Confirmation and Menus) since the AV COMPU LINK Remote Control System automatically changes
the TV input mode to “Video input 1” when you operate the S-VHS VCR.
If you do not mind stopping watching the picture, you can then show the on-screen displays after changing
the TV input mode to the position (Video input 2) the receiver is connected to.
77
77
7 Automatic Selection of TV’s Input Mode
When you select “TV SOUND” as the source to play on the receiver, the TV automatically changes the input
mode to the TV tuner so that you can watch TV.
When you select “VIDEO” as the source to play on the receiver, the TV automatically changes the input
mode to the Video Input 2 so that you can watch the playback picture.
When you select “VCR” as the source to play on the receiver, the TV automatically changes the input mode
to the correct position (either Video Input 1 or 2) so that you can watch the playback picture.
Note:
When you select “TV SOUND” as the source on the receiver, you cannot see the on-screen displays (such as
Visual Confirmation and the menu function) since the AV COMPU LINK remote control system automatically
changes the TV’ input mode to the TV tuner.
If you do not mind stopping listening to the TV sounds, you can then show the on-screen displays after changing
the TV input mode to the position (Video input 2) the receiver is connected to.
77
77
7 Automatic Power On/Off
The TV and VCR turn on and off along with the receiver.
When you turn on the receiver;
If the previously selected source is “VCR,” the TV and VCR will turn on automatically.
If the previously selected source is “VIDEO” or “TV SOUND,” only the TV will turn on automatically.
When you turn off the receiver, the TV and VCR will turn off.
Note:
If you turn off the receiver while recording on the VCR, the VCR will not turn off, but continue recording.
RX-772VBK[J]_0052-001A.En.31-37 97.4.8, 3:27 PM37