Filter
Top Products
Page 29
From the remote control:
Note:
If you want to use the remote control for adjusting the center mode and the center tone, use the menu function
(see page 34).
1. Press SOUND CONTROL.
The remote control is activated for adjusting the sound.
2. Press SURR MODE until “PROLOGIC” or “3CHLOGIC” whichever you want appears on the
display.
The PRO LOGIC or 3CH LOGIC indicator (as well as the SURROUND indicator) also lights up.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):
3. Press DELAY to adjust the delay time of the rear speaker output.
Each time you press the button, the delay time changes as follows:
Note:
When you have selected “3CHLOGIC,” you cannot adjust the delay time.
4. Press TEST to start checking the speaker output balance.
“TEST” starts flashing on the display, and a test tone comes out from the speakers in the following
order:
Notes:
• No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”
• No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center
mode.
5. If necessary, adjust the speaker output balance as follows:
• To adjust the rear speaker output level, press REAR +/–.
• To adjust the center speaker output level, press CNTR +/–.
Pressing – decreases the output level up to –10 dB.
Pressing + increases the output level up to +10 dB.
Notes:
• You cannot adjust the left and right rear speakers output level separately.
• You cannot adjust the rear speakers output level when you have selected “3CHLOGIC.”
• You cannot adjust the center speaker output level when you select “PHANTOM” or “OFF” for the
center mode.
6. Press TEST again to stop the test tone.
SOUND
CONTROL
+10
SURR MODE
100+
TEST
4
Remote Control
Left front speaker
Center speaker
Rear speakers
Right front speaker
DELAY 1
DELAY 2
DELAY 4
DELAY 3
DELAY
1
TEST
4
REAR
56
CNTR
23
PROLOGIC 3CHLOGIC
SURR OFF
HALL
(Surround Off)
RX-772VBK[J]_0052-001A.En.24-30 97.4.8, 3:25 PM29