Filter
Top Products
Page 35
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate JVC audio components through the remote
sensor on the receiver.
To use this remote control system, you need to connect JVC audio components through the COMPU LINK-
3 (SYNCHRO) jacks (see below) in addition to the connections using cables with RCA pin plugs (see page
8).
Notes:
• If your audio component has two COMPU LINK-3 (SYNCHRO) jacks, you can use either one. If it has only
one COMPU LINK-3 (SYNCHRO) jack, connect it so that it is the last item in the series of components. (For
example, the turntable or CD player in the diagram above.)
• Refer also to the manuals supplied with your audio components.
This remote control system allows you to use four functions listed below.
77
77
7 Remote Control through the Remote Sensor on the Receiver
You can control the connected audio components through the remote sensor on the receiver using this remote
control. For details, see pages 38 and 39.
Note:
Aim the remote control directly at the remote sensor on the receiver.
77
77
7 Automatic Source Selection
When you press the play (
33
33
3) button on a connected component or on its own remote control, the receiver
automatically turns on and changes the source to the component. On the other hand, if you select a new source
on the receiver or the remote control, the selected component begins playing immediately.
In both cases, the previously selected source continues playing without sound for a few seconds.
77
77
7 Automatic Power On/Off (only possible with the COMPU LINK-3 connection)
Both the CD player and cassette deck turn on and off along with the receiver.
When you turn on the receiver, the CD player or cassette deck will turn on automatically, depending on which
component has been previously selected.
When you turn off the receiver, both the CD player and cassette deck will turn off.
77
77
7 Synchronized Recording
Synchronized recording means the cassette deck starts recording as soon as a CD or a record begins playing.
To use synchronized recording, follow these steps:
1 Put a tape in the cassette deck, and a disc in the CD player (or a record on the turntable).
2 Press the record (¶) button and the pause (8) button on the cassette deck at the same time.
This puts the cassette deck into recording pause.
Note:
If you do not press the record (¶) button and pause (8) button at the same time, the synchronized recording
feature will not operate.
3 Press the play (3) button on the CD player or on the turntable.
The source changes on the receiver, and as soon as play starts, the cassette deck starts recording.
When the play ends, the cassette deck enters recording pause, and stops about 4 seconds later.
Notes:
• During synchronized recording, the selected source cannot be changed.
• If your CD player is playing in program mode, a 4-second blank is recorded between tracks so that the music
scan feature of your cassette deck can be used on the recorded tape.
• If the power of any component is shut off during synchronized recording, the COMPU LINK remote control
system may not operate properly. In this case, you must start again from the beginning.
Turntable
Cassette deck
CD player
COMPU LINK – 3
(SYNCHRO)
RX-772VBK[J]_0052-001A.En.31-37 97.4.8, 6:36 PM35