Filter
Top Products
Page 21
Assigning Names to Preset Stations
You can assign a name of up to five characters to each preset station (from preset channel number 1 to 20).
When a preset station is tuned in, its assigned name will appear on the display.
On the front panel only:
1. Tune in a preset station (preset channel number 1 to 20).
See page 20 for details.
2. Press MEMORY (next to the TUNER button).
The preset channel number starts flashing.
Note:
If you press Control
%
/
fi
while the preset
channel number is flashing, you can change the
preset channel number.
3. Press Control
##
##
# (or
@@
@@
@) until the first character
position starts flashing.
4. Press Control
%%
%%
% /
fifi
fifi
fi to select a character.
You can use the characters listed below.
5. When a character you want appears, press
Control
##
##
# (or
@@
@@
@).
The next (or previous) character position starts
flashing.
6. Repeat steps 4 and 5 to enter up to five characters.
7. Press MEMORY (next to the TUNER button) again, while the last selected character is
flashing, after you have assigned a name.
To erase the input characters
Insert blanks using the same procedure described above.
SURROUND PRO LOGIC
VISUAL CONFIRMATION
CH–
100 1k 10k
MEMORYTUNER
MENU
See also
page 33.
SURROUND PRO LOGIC
VISUAL CONFIRMATION
CH–
100 1k 10k
SURROUND PRO LOGIC
VISUAL CONFIRMATION
CH–
100 1k 10k
SURROUND PRO LOGIC
VISUAL CONFIRMATION
CH–
100 1k 10k
MEMORYTUNER
Front panel
Available characters
CBADEGFHIJKLMNO
SRQTUWVX
Y
Z01234P
87695
Blank
RX-772VBK[J]_0052-001A.En.01-23 97.4.8, 3:24 PM21