Filter
Top Products
4
SUBWOOFER
OUT
INPUT
HIGH IMPEDANCE
Powered subwoofer
(example)
Getting Started
1
2
3
Speaker Layout Diagram
Connecting the Speakers
After connecting the front, center, rear speakers and/or a subwoofer,
set the speaker setting information properly to obtain the best
possible DSP effect. For details, see page 12.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting the front, center, and rear speakers
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers respectively.
1 Cut, twist and remove the insulation at the end of
each speaker cord (not supplied).
2 Open the terminal, then insert the speaker cord.
3 Close the terminal.
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or reproduce
the original LFE signals recorded in the digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with RCA
pin plugs (not supplied).
• Refer also to the manual supplied for your subwoofer.
Since bass sound is non-directional, you can place a
subwoofer wherever you like. Normally place it in front of
you.
·
ª
·
ª
Right rear speaker
EN01-07.RX-E100SL[J]_f 01.3.7, 2:47 PM4