Filter
Top Products
19
ANALOG
PRO LOGIC
SUBWFRLFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
Adjusting the Tone
You can adjust the bass and treble sounds as you like.
• You have to make these adjustments for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
adjustments.
2
Press CONTROL ∞ (or 5) repeatedly until
“BASS” or “TREBLE” (with the current
setting)
* appears.
BASS : To adjust the bass.
TREBLE :To adjust the treble.
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
3
Press CONTROL 3 or 2 to adjust the sound
level.
• Pressing CONTROL 3 increases the sound level by +2 steps
(from –10 to +10).
• Pressing CONTROL 2 decreases the sound level by –2 steps
(from +10 to –10).
4
Repeat steps
2
and
3
to adjust the other sound
level.
Sound Adjustments
ADJUST
ANALOG
PRO LOGIC
SUBWFRLFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
Ex.: When adjusting the bass level
Remote
NOT
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have connected a
subwoofer and set the subwoofer information correctly – “YES.”
• You have to make this adjustment for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
adjustments.
2
Press CONTROL ∞ (or 5) repeatedly until
“SUBWFR (subwoofer)” (with the current
setting)
* appears.
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
3
Press CONTROL 3 or 2 to adjust the sound
output level.
• Pressing CONTROL 3 increases the sound output level
(from –10 to +10).
• Pressing CONTROL 2 decreases the sound output level
(from +10 to –10).
When using the remote control
1
Press SOUND.
10 keys now work for sound adjustments.
2
Press SUBWOOFER +/– to adjust the sound output level
(from –10 to +10).
ADJUST
CONTROL
CONTROL
CONTROL
OGIC
VOL
AUTO
ATT
ANALOG
PRO LOGIC
SUBWFRLFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
EN17-19.RX-E100SL[J]_f 01.3.7, 2:50 PM19