Filter
Top Products
15
Basic Settings
C
VOL
O
CONTROL
Dynamic Range Compression — D.R.C.
You can compress the dynamic range (difference between maximum
sound and minimum sound) of the reproduced sound. This is useful
when enjoying surround sound at night.
• This function takes effect only when playing back a source using
Dolby Digital.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL∞ (or 5) repeatedly until
“D.R.C. (Dynamic Range Compression)” (with
the current setting)
* appears on the display.
* “MID” is the initial setting. If you have already changed the
setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate compression level.
• Each time you press the button, the compression level changes
as follows:
OFF :Select this when you want to enjoy surround with its
full dynamic range. (No effect applied.)
MID :Select this when you want to reduce the dynamic range
a little.
MAX :Select this when you want to apply the compression
effect fully. (Useful at night.)
SETTING
CONTROL
ANALOG
PRO LOGIC
SUBWFRLFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
IC
VOL
T
O
T
Low Frequency Effect Attenuator — LFE
If the bass sound is distorted while playing back software using
Dolby Digital or DTS Digital Surround, follow the procedure below.
• This function takes effect only when the subwoofer (LFE) signals
come in, (with “SUBWFR” set to “YES”).
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL ∞ (or 5) repeatedly until “LFE
(Low Frequency Effect)” (with the current
setting)
* appears on the display.
* “0” is the initial setting. If you have already changed the
setting, “–10dB” will be shown.
3
Press CONTROL 3 (or 2) to select the LFE
attenuator level.
• Each time you press the button, the LFE attenuator level
changes as follows:
0dB : Normally select this.
–10dB : Select this when the bass sound is distorted.
SETTING
ANALOG
PRO LOGIC
SUBWFRLFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
EN08-16.RX-E100SL[J]_f 01.3.7, 2:49 PM15