Filter
Top Products
57
This remote control supplied with the receiver can transmit control
signals for other manufacturers’ VCRs, TVs, CATV converters and
DBS tuners. By changing the transmittable signals from preset ones
to the other manufacturers’, you can operate the other
manufacturer’s components using this remote control.
When operating the other manufacturers’ components, refer also to
the manuals supplied with them. To operate these components with
the remote control, first you need to set the manufacturer’s code
each for VCR, TV, CATV converters, and DBS tuner.
Operating Other Manufacturers’ Video Equipment
To change the transmittable signals for operating
another manufacturer’s TV ———————————
1. Set the remote control mode to “AUDIO/TV/VCR.”
2. Press and hold TV/CATV/DBS POWER.
3. Press TV/DBS.
4. Enter manufacturer’s code (three digits) using
buttons 1 – 9, and 0.
See the list on pages 59 and 60 to find the code.
Examples: For a JVC product, press 0, 5, then 3.
For a Hitachi product, press 0, 5, then 6.
5. Release TV/CATV/DBS POWER.
The following buttons can be used for operating the TV (with
the remote control mode selector set to “AUDIO/TV/VCR”):
TV/CATV/DBS POWER : Turns on and off the TV.
TV VOL +/– : Adjusts the volume.
TV/VIDEO : Sets the input mode (either TV or VIDEO).
After pressing TV/DBS (with the remote control mode selector
set to “AUDIO/TV/VCR”), you can perform the following
operations on a TV:
CHANNEL +/– : Changes the channels.
1 – 10, 0, 100+ (+10) : Selects the channels.
100+ (+10) button will function as the
ENTER button if your TV requires
pressing ENTER after selecting a channel
number.
Note:
• Refer to the manual supplied with your TV.
6. Try to operate your TV by pressing TV/CATV/DBS
POWER.
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV, try
each one until the correct one is entered.
Manufacturer Code Manufacturer Code
JVC 01 SAMSUNG 12
HITACHI 10 SANYO 13
MAGNAVOX 02 SHARP 06
MITSUBISHI 03 SONY 07
PANASONIC 04, 11 TOSHIBA 08
RCA 05 ZENITH 09
Manufactures’ codes are subject to change without notice. If they
are changed, this remote control cannot operate the equipment.
Check to see if its
remote control mode
selector is set to the
correct position.
To operate the audio
system, TVs, and
VCRs, set it to
“AUDIO/TV/VCR.”
To operate the CATV
converter and DBS
tuner, set it to
“CATV/DBS.”
Primary remote control
TH-A10[J]7/1 00.2.24, 14:5957