Filter
Top Products
English
43
Changing the VFP Setting
The VFP (Video Fine Processor) function enables you to adjust the
picture based on the picture tone, or personal preference.
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
& During playback
1
Press VFP.
The current VFP setting screen appears on the TV.
Ex.: When “NORMAL” is selected.
2
Press cursor 3 / 2 repeatedly to select the VFP
mode.
• Each time you press the button, the VFP mode changes as
follows.
NORMAL “ CINEMA “ USER1 “ USER2 “
(back to the beginning)
NORMAL Normally select this.
CINEMA Suitable for a movie source.
USER1/USER2 You can adjust parameters that affect the
appearance of picture and can store the
settings (see below).
To turn off the VFP setting screen
Press VFP.
If no operations are done for about 10 seconds
The VFP setting screen disappears.
To adjust the appearance of the picture
You can adjust the appearance of picture and store in “USER1” and
“USER2.”
& During playback
1
Press VFP, then press cursor 3 / 2 repeatedly to
select “USER1” or “USER2.”
Ex.: When “USER1” is selected.
OFF
NORMAL
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
+
0
+
0
+
0
+
0
+
0
OFF
USER1
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
+
0
+
0
+
0
+
0
+
3
3
GAMMA
3
GAMMA
DVD
DVD
SVCD
SVCD
VCD
VCD
2
Press cursor ∞ / 5 repeatedly to select a
parameter you want to adjust.
Adjust the parameters so that the picture you are viewing
appears as you prefer.
GAMMA Adjust if the neutral color is bright or dark.
The brightness of dark and bright portions is
maintained.
Available range: OFF, 1 (darkest) to 3
(brightest)
BRIGHTNESS Adjust if the picture is bright or dark as a
whole.
Available range: –8 (darkest) to +8
(brightest)
CONTRAST Adjust if the far and near position is
unnatural.
Available range: –7 to +7
SATURATION Adjust if the picture is whitish or blackish.
Available range: –7 (most blackish) to +7
(whitest)
TINT Adjust if the human skin color is unnatural.
Available range: –7 to +7
SHARPNESS Adjust if the picture is indistinct.
Available range: –8 to +8
3
Press ENTER.
VFP parameters list disappears, and the following pop-up
window for the selected item appears on the TV.
Ex.: When “GAMMA” is selected.
4
Press cursor ∞ / 5 repeatedly to select the
setting, then press ENTER.
Your adjustment is stored and the current VFP parameter list
appears again.
5
Repeat steps
2
to
4
to adjust other parameters.
To turn off the VFP setting screen
Press VFP.
To activate your setting
Press VFP, then press cursor 3 / 2 repeatedly to select
“USER1” or “USER2.”
If no operations are done for about 10 seconds
The VFP setting screen disappears.
Advanced Disc Operations (continued)
38-43HX-Z77&55[U]6.p65 03.8.18, 10:43 AM43