Filter
Top Products
24
English
You can play back type I tapes.
Playing Back a Tape
1
Press 0 EJECT for the cassette deck.
2
Insert a cassette with the exposed part of the tape
down.
3
Close the cassette holder gently.
4
Press TAPE 2 3.
The tape play starts and the tape direction indicator (3 or 2)
starts flashing slowly to indicate the tape’s running direction.
• Each time you press the button, “REVERSE” appears for a
while on the display and the tape direction changes.
33
33
3: plays the front side.
22
22
2: plays the reverse side.
• If no cassette is inserted, “NO TAPE” appears on the display.
When the tape plays to the end, the deck automatically stops if
the Reverse mode is off. (See “To play both sides repeatedly—
Reverse mode.”)
To stop playing, press 7.
To fast-wind to the right or to the left, press ¡ or 1 while the
tape is not running.
The tape direction indicator (3 or 2) starts flashing quickly on the
display.
• When using the remote control, you can also use ¢ / 4.
To remove the cassette, press 0 EJECT to open the cassette holder.
To play both sides repeatedly—Reverse mode
When using the Reverse mode, the tape automatically reverses at the
end of one side, starts playing the other side of the tape, and repeats
the same process.
On the remote control:
Press REV. MODE while holding down SHIFT.
On the front panel:
Press REVERSE MODE.
The Reverse mode indicator lights up on the display like— .
To cancel the Reverse mode, press the button again so that the
Reverse mode indicator lights up on the display like—
.
Locating the Beginning of a Song—Music Scan
You can use Music Scan to locate the beginning of a song. Music
Scan searches for blank portions that usually separate recorded
songs, then plays the next song.
7 To find the beginning of the current song
During play, press ¡ or 1 in the opposite direction to the tape
play.
The tape direction indicator of the opposite direction to the tape play
starts flashing intermittently.
Searching stops automatically at the beginning of the current song,
and it starts automatically.
• When using the remote control, you can also use ¢ / 4.
7 To find the beginning of the next song
During play, press ¡ or 1 in the same direction as the tape is
playing.
The tape direction indicator of the same direction as the tape is
playing starts flashing intermittently.
Searching stops automatically at the beginning of the next song, and
the song starts automatically.
• When using the remote control, you can also use ¢ / 4.
Music Scan works by detecting a 4-second long blank
between each song, so it will not work well in the
following cases
• No blank at the beginning of a song.
• Noise (often caused by much use or poor quality dubbing) which
fills the blank.
• Long, very soft passages or pauses in a song.
The use of C-120 or longer tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
21-24HX-Z77&55[U]6.p65 03.8.18, 10:42 AM24