Filter
Top Products
13
English
Setting the Clock
You can set the clock when the unit is either turned on or off (on
standby).
5
Press SET/DISPLAY to finish setting the clock.
“CLOCK OK” appears on the display, then the built-in clock
starts.
To check the clock time while playing a source
Press and hold SET/DISPLAY.
•
Each time you press and hold the button, the source indication and
the clock time alternate on the display.
To adjust the clock again
If you have set the clock before, press CLOCK/TIMER
repeatedly until the clock setting mode is selected.
• Each time you press the button, the clock/timer setting modes
change as follows:
When you unplug the AC power cord or if a power
failure occurs
The clock loses its setting and resets to “0:00.” If this happens, set
the clock again.
The clock may gain or loss 1 to 2 minutes per month
If this happens, set the clock again.
On the front panel ONLY:
1
Press CLOCK/TIMER.
“0:00” appears on the display with the hour digit flashing.
2
Turn ¢ / 4 to adjust the hour.
• As you turn the control, the hour digit changes continuously.
3
Press SET/DISPLAY to set the hour.
The minute digit starts flashing.
• If you want to change the hour again, press CANCEL/DEMO.
The hour digit starts flashing again.
4
Turn ¢ / 4 to adjust the minute.
• As you turn the control, the minute digit changes continuously.
DAILY
(Daily Timer on/off)
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
(Recording Timer on/off)
Clock
setting
(The hour digits start flashing.)
Getting Started (continued)
01-13HX-Z77&55[U]6.p65 03.8.18, 10:42 AM13