Filter
Top Products
29
being trimmed to a program source rather
than the test tone, as shown on page 36.
When all channels have an equal volume
level, the adjustment is complete. To exit
this menu, press the
⁄
/
¤
Buttons n
until the on-screen
›
cursor is next to the
BACK TO MASTER MENU line,
and then press the
Set Button p to
return to the
MASTER MENU.
The output levels may also be adjusted
at any time using the remote control and
semi-OSD system. To adjust the output
levels in this fashion, press the
Test
Button
i. As soon as the button is
pressed, the test tone will begin to circu-
late as indicated earlier. The correct
channel from which the test noise should
be heard will be shown in the lower third
of the video screen and in the
Lower
Display Line
B. While the test noise is
circulating, the proper channel position
will also be indicated in the
Speaker/
Channel Input Indicators
E by a
blinking letter within the correct channel.
To adjust the output level, press the
⁄
/
¤
Buttons n until the desired
level is shown in the display or on-
screen. Once the buttons are released,
the test noise will begin to circulate
again in five seconds.
When all channels have the same output
level, press the
Test Button i again
to complete the process.
NOTE: Output level adjustment is not
available for the VMAx or Surround Off
modes.
Additional Input Adjustments
After one input has been adjusted for
Surround mode, digital input (if any),
speaker type, and output levels, go back
to the
INPUT SETUP line on the
MASTER MENU (Figure 1) and enter
the settings for each input that you will
use. In most cases, only the digital input
and surround mode will be different from
one input to the next, while the speaker
type, crossover frequency, Night mode
and output level settings will usually be
the same and may be quickly entered
by entering the same data used for the
first input.
When all settings and adjustments have
been made, press the
OSD Button v
to return to normal operation of the AVR.
Once the settings outlined on the previ-
ous pages have been made, the AVR580
is ready for operation. While there are
some additional settings to be made,
these are best done after you have had
an opportunity to listen to a variety of
sources and different kinds of program
material. These advanced settings are
described on pages 37–38 of this manual.
In addition, any of the settings made in
the initial configuration of the unit may
be changed at any time. As you add new
or different sources or speakers, or if you
wish to change a setting to better reflect
your listening taste, simply follow the
instructions for changing the settings for
that parameter as shown in this section.
Having completed the setup and configu-
ration process for your AVR580, you are
about to experience the finest in music
and home theater listening. Enjoy!