Filter
Top Products
47
First Time Setup
This section explains the settings that you need to make before using the AV receiver for the very first time.
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
Speaker Type setting. For hookup information, see pages
25 and 26.
Notes:
• When bi-amping is used, the AV receiver is able to
feed up to 5.1 speakers in the main room.
• When bridging is used, the AV receiver is able to drive
up to 2.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Speaker Settings
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
-
TV CH
TV VOL
--
/
---
10 11 12
D.TUN
+10
0
Clear
456
789
Input Selector
Tape
Tuner
CD
Phono Net/USB
Game
/
TV
Macro
123
VCRDVD
CDR/MD/Dock
CD
Zone
2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver
TV
Net/USB
Cable
VOL
CH
Disc
Album
+
-
Enter
T
o
p
M
e
n
u
M
e
n
u
Display Muting
E
x
i
t
G
u
i
d
e
Prev
CH
R
e
t
u
r
n
S
e
t
u
p
Playlist
RandomRec
SAT
Zone
3
AUX 1 AUX 2
2, 3
2–5
1
1, 6
If you change these settings, you must run the auto-
matic speaker setup again (see page 55).
Receiver
S
e
t
u
p
Enter
Enter
3
Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker Set-
tings,” and then press [Enter].
The Speaker Settings menu appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Speaker
Impedance,” and use the Left and
Right [ ]/[ ] buttons to select:
4 ohms:
Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms:
Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ]
buttons to select “Speaker Type,”
and use the Left and Right
[ ]/[ ] buttons to select:
Normal:
Select this if you’ve con-
nected your front speakers
normally.
Bi-Amp:
Select this if you’ve con-
nected your front speakers for
bi-amped operation.
BTL:
Select this if you’ve con-
nected your front speakers for
bridged operation. The BTL
indicator will appear on the
display.
6
Press the [Setup] button.
Setup closes.
Enter
Enter
2-1.Speaker Settings
Speaker Impedance
6ohms
Speakers Type Normal
Enter
Enter
S
e
t
u
p