Filter
Top Products
133
Controlling Other Components
—Continued
Remote Control Codes for Integra/Onkyo
Components Connected via
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to con-
trol components that are out of view, in a rack, for exam-
ple.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not con-
nected via , use the following remote control codes:
•[DVD] Remote Mode button
5001:
Integra/Onkyo DVD player without
(default)
• [CD] Remote Mode button
6001:
Integra/Onkyo CD player without
(default)
• [MD] Remote Mode button
6007:
Onkyo MD recorder without
• [CDR] Remote Mode button
6005:
Onkyo CD recorder without
• [Dock] Remote Mode button
6003:
Onkyo RI Dock DS-A2 without (default)
Note:
• If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote oper-
ation to work properly, you must set the Input Display
to MD or CDR, respectively (see page 52).
Resetting the Remote Mode Buttons
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
1
Make sure the Integra/Onkyo component
is connected with an cable and an
analog audio cable (RCA).
See page 45 for details.
2
Enter the appropriate remote control code
to the Remote Mode button.
•[DVD] Remote Mode button
5002:
Integra/Onkyo DVD player with
• [CD] Remote Mode button
6002:
Integra/Onkyo CD player with
• [MD] Remote Mode button
6008:
Onkyo MD recorder with
• [CDR] Remote Mode button
6006:
Onkyo CD recorder with
• [Dock] Remote Mode button
6004:
Onkyo RI Dock DS-A1 with
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
1
While holding down the Remote
Mode button that you want to
reset, press the TV [ ] button.
The Remote indicator flashes three
times.
2
Press the Remote Mode button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra/Onkyo DVD players and CD
players, respectively. When these but-
tons are reset, the preprogrammed
codes are restored.
Resetting the Remote Controller
1
While holding down the
[Receiver] Remote Mode button,
press the [Standby] button.
The Remote indicator flashes five
times.
2
Press the [Receiver] Remote
Mode button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
VCRDVD
CDR/MD/Dock
CD
Remote Mode
TV
Net/USB
Cable
SAT
TV
VCRDVD
CDR/MD/Dock
CD
Remote Mode
TV
Net/USB
Cable
SAT
Receiver
Standby
Receiver