Filter
Top Products
67
Using a Macro function
Erasing all commands and macros that have
been programmed
This procedure will erase all the commands and macros that you
have programmed into the remote controller and return it to its
default settings. This operation will not affect the preset settings of
the remote controller.
1. Open the battery cover and remove the
batteries from the remote controller.
2. While pressing and holding down the ON and
STNBY buttons, re-insert the batteries in their
correct orientation, and then release both
buttons.
The SEND/LEARN indicator flashes slowly and “CLEAR”
appears in the display.
3. Press the ENT button.
The SEND/LEARN indicator lights up for about ten seconds
and then turns off and “AUDIO” appears in the display.
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; otherwise, the
batteries will be consumed quickly.
• If you press any button other than the ENT button in Step 3,
nothing will be erased. In this case, resume from Step 1.
MACRO MODE MODE MODE MODE MODE MODE MODE MODE DIRECT
MACRO MACRO MACRO MACRO MACRO MACRO MACRO MACRO MACRO
↓↓↓↓↓↓↓ ↓
AUDIO CD DVD MD SAT CABLE VCR TV
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16
HOME THEATER CONTROLLER
RC-418M
OPEN/CLOSEREC
AUDIO MUTING
DISCTRACK
DVD
CD
PH
TUN
T2T1
V1
STEREO
123
654
7
+
10 0
ENT
89
SURROUND THX DSP
LEVEL
+
CH SELRe-EQ
LEVEL
–
DIMMERLATE NIGHT
DIRECT DSP
V2 V3 V
–
ON
STNBY
ENT
Macro mode programming memo: