Filter
Top Products
37
Input Setup
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
2.Input Setup
Input:DVD
a.Audio Setup
b.Video Setup
c.Listening Mode Preset
d.Tone Control
e.IntelliVolume
f.12V Trigger
|ENTER| Quit:|OSD|
2-3.ListeningMode Preset
Input:DVD
a.2ch Source
:Stereo
b.PCM fs=96k :Stereo
c.Multichannel,Mono
Source :Surround
Quit:|OSD|
Relationship between input source and listening mode
The listening modes that can be set are different for each input source format.
Note:
You may not be able to select all the listening modes shown here depending on your speaker configuration or the selected input
source.
* The 5.1-channel digital surround format has a variety of
versions including Dolby Digital and DTS. The 5.1- channel
digital surround format enables you to individually record and
play five full-range (20 Hz to 20 kHz) channels (left and right
front, center, and two surround channels) plus an LFE channel
(Low Frequency Effect) for the low-range effect sound. It will
create a realistic sound that can be heard in the theaters and
concert halls.
2-3. Listening Mode Preset sub-menu
With the DTR-7.1, you can set a different listening mode for each
different signal type that comes from each input source and also
set the parameters for the listening mode itself. For example, if
your DVD player also plays compact discs and the DVD video
signal is DTS and the compact disc signal is PCM, then you can set
a different listening mode for each.
This is especially convenient if you frequently play the same types
of movies or music.
Input source signals
a. 2ch Source
Set a listening mode for the input signal from 2-channel analog
sources, PCM sources, and 2/0-channel Dolby Digital and DTS
sources.
b. PCM fs=96k
Set a listening mode for the input signal from digital PCM sources
recorded with a sampling rate of 96 kHz.
c. Multichannel, Mono Source
Set a listening mode for the input signal from 2/1, 2/2, 3/0, 3/2-
channel Dolby Digital and DTS sources. Or, set a listening mode
for the input signal from 1/0-channel (Mono) Dolby Digital and
DTS sources.
• The DTR-7.1 will automatically switch to the listening mode
set for the current input signal. For example, even when using
the same DVD player, if a CD is played, the listening mode
automatically becomes “Stereo,” and if a DVD is played
(Dolby Digital 3/2.1), the listening mode automatically
becomes Dolby D.
Input source signal (display)
2ch PCM fs=96k Multichannel, Mono
Type of software Tape, CD, DVD DVD, LD,
Record, Tuner Digital satellite
DVD Video (Stereo), LD (Stereo) broadcast
Digital satellite DTS-CD
Listening Mode broadcast
Direct ●●
Stereo ●●●
Theater-Dimensional ●●
Surround ●●
(Pro Logic (3 Stereo), (DolbyD,
DolbyD, DTS) Dolby D6.1, DTS,
DTS-ES)
THX ●●
(Cinema) (Cinema,
Surround EX)
Mono Movie ●●
Enhanced 7 ●●
Orchestra ●●
Unplugged ●●
Studio-Mix ●●
TV Logic ●●
All Ch Stereo ●