Filter
Top Products
10
Front panel facilities
Front panel display
SLEEP indicator
PCM DIGITAL indicator
Listening mode or digital input format indicator
MEMORY indicator
FM STEREO indicator
Lights when tuned into an FM radio broadcast in stereo.
TUNED indicator
AUTO indicator
Multi function display
Character/Memory button
This button is used to program names to preset radio stations and
input sources, to change names previously programmed, or to
delete names. This button is also used to assign the radio station
that is currently tuned in to a preset channel or delete a previously
preset station.
Bass/Treble button
Press to enter the mode for adjusting the bass and treble levels.
CH Level button
Press to select the channel whose level is to be adjusted.
Zone 2 Vol button
Press to enter the mode for adjusting the volume in the remote
zone (Zone 2).
Smart Scan Controller (SSC) dial
Turn clockwise or counterclockwise to select the setting for the parameter
displayed in the front display. Press to move to the next parameter.
Display button
The Display button is used to display information about the
current input source signal. Each time you press the display
button, the screen changes to show you different information
concerning the input signal.
When an input source other than FM or AM is selected:
Listening Mode buttons
Press these buttons to select a listening mode for the current input source.
DIRECT: Select for direct audio output that does not pass through
sound alteration circuits and other filters.
STEREO: Select for normal stereo output.
j/DTS SURROUND: Select for the Dolby Pro Logic, Dolby
Digital, or DTS listening modes.
THX: Select for the THX listening mode.
Remote control sensor
Menu button
Press to bring up the OSD menu. The OSD menu will apear on the
TV monitor as well as the front display on the DTR-7.1.
and buttons
When selecting items in the OSD Menu, press these buttons to move the
on-screen cursor (or the highlighted portion) upward and downward.
Exit button
Press to exit the OSD menu when at the Menu Screen, or move to
one screen previous to the one that is displayed if at any other screen.
1) You can program text name for each input source (see page
52). That text name will be displayed at this time.
2) If the input signal does not have a program format, then this
will be skipped.
When FM or AM is seelcted as the input source:
FA/AM frequency +
Preset no.
2)
FM/AM +
Listening mode
Text name or
frequency +
Preset no.
1)
ch
ch
Input or text
name +
volume
1)
Program format
2)
Input +
Listening mode
1)
Not displayed if there is no text name programmed for the preset
channel.
2) If a text name is programmed for the preset channel, display
“2” is displayed for 3 seconds each time the input is changed
from FM to AM or vice versa.