Filter
Top Products
5 Configuration of WLAN
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-1
5 Configuration of WLAN
5.1 Setting Up a Wireless Connection by the Wi-Fi
Butto
Step 1
button on the side panel and hold it for more than four seconds to enter
the WPS negotiation state. The Wi-Fi indicator starts to blink slowly in a few seconds.
n
The terminal supports the WPS function. If your network adapter also supports the WPS
function, you can use the WPS function to set up
a wireless connection between your PC
and the terminal quickly. To set up a wireless connection, do as follows:
Press the Wi-Fi
y default, the Wi-Fi function of the terminal is enabled
z B . Press the Wi-Fi button on the side
z I ink, it indicates that the WPS function cannot be enabled.
of the WLAN is set
Step 2
nable the WPS negotiation
Step 3
a few seconds, and then you can see the wireless icon on the corner to the right
k bar of the PC.
----End
5.2 Se
lly. To manually set up a wireless
z
panel and hold it for less than four seconds to disable the Wi-Fi function, and hold it for
more than four seconds to enable the WPS function.
f the Wi-Fi indicator does not bl
Note that the WPS function can be used only when the security m
ode
to WPA-PSK or WPA2-PSK.
Access the WLAN through the wireless network adapter on your PC.
After you install a wireless network adapter on your PC and e
function, the wireless network adapter automatically searches for an available wireless
network and connect to the wireless network automatically.
Wait for
of the tas
tting Up a Wireless Connection Manually
If your network adapter does not support the WPS function, you can set up a wireless
connection between your PC and the terminal manua
connection, use either
of the following methods:
z
Use the tool provided by your network adapter.
For details, see the user guide of your network adapter.
Use the wireless configuration software provided by the operating system of your
PC.