Filter
Top Products
4 Configuring the WAN Interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-5
Table 4-3 Parameters for the PPP Username and Password page
Parameter Description
PPP Username
The user name of the PPP, which is provided by the
Internet Service Provider.
PPP Password
The user name of the PPP, which is provided by the
Internet Service Provider.
PPP's MTU:[296-1492]
The maximum length of the transported IP package
with the se
lected PPPoA protocol.
PPP's LCP Echo-req
Interval:[10-60]
It specifies the time interval of the two echo-requests.
Authentication Method The authentication method of the PPP protocol.
Step 10
Click
Next
to show the
Enable WAN Service
page, just keep the default settings. Make
sure choose
Data
in the
Service Name
drop-down list box.
Step 11
Click
Nex
t
to show the
WAN Setup-Summary
page, click
Save
to save the settings.
Click Back to make any modifications. Reboot the terminal so that the settings take effect.
----End
4.1.2 Configuring the PPPoE Mode
To configure the PPPoE mode for the WAN interface, do as follows:
Step 1
Repeat from the
step1 to the step 7 of
4.1.1 "Configuring the PPPoA Mode."
Step 2
On the
Conne
c
tion Type
page, select
PPP over Ethernet (PPPoE)
. Keep other settings
by the Internet Service Provider.
Step 3
Click
Next
to show the
PPP Username and Password
page for PPPoE, you can keep
the default settings or set the parameters refer to Table 4-4.