Filter
Top Products
4 Configuring the WAN Interface
4-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4.1.4
Figure 4-6
Configuring the IPoA Mode
To configure the IPoA mode for the WAN interface, do as follows:
Step 1
Repeat from the
step1 to the step 7 of
4.1.1 "Configuring the PPPoA Mode."
Step 2
On the
Conne
c
tion Type
page, select
IP over ATM (IPoA)
.
Step 3
Click
Ne
xt
to show the
WAN IP Settings
page for IPoA, you can keep the default
settings or set the parameters refer to
Table 4-6.
WAN IP Settings page for
IPoA
Table 4-6 Parameters for the WAN IP Settings page for
IPoA
Parameter Description
WAN IP Address It specifies the WAN IP address of the PVC.
This parameter is provided by the Internet Serv
ice Provider.
WAN Subnet Mask It specifies the WAN subnet mask of the PVC.
This parameter is provided by the Internet Serv
ice Provider.
Remote WAN IP
address
It specifies the remote WAN IP address of the PVC.
This parameter is provided by th
e Internet Serv
ice Provider.
Primary DNS server
It specifies the IP address of the primary DNS server used
by t
he PVC.
This parameter is provided by the Internet Serv
ice Provider.
Secondary DNS
server
It specifies the IP address of the secondary DNS server used
by the PVC.
This parameter is provided by the Internet Service Provider.
IpoA's
MTU:[296-1500]
The maximum length of the transported IP package with the
selected IPoA protocol.