Harman-Kardon AVR 330 Stereo Receiver User Manual


 
AVR 330 AUDIO/VIDEO RECEIVER
3 Introduction
4 Safety Information
4 Unpacking
5 Front-Panel Controls
7 Rear-Panel Connections
10 Main Remote Control Functions
14 Zone II Remote Control Functions
15 Installation and Connections
17 System Configuration
17 Speaker Placement
17 System Setup
18 Input Setup
19 Surround Setup
20 Speaker Setup
22 Delay Settings
23 Output Level Adjustment
23 Using EzSet
24 Manual Output Level Adjustment
25 Operation
25 Basic Operation
25 Source Selection
25 6-Channel/8-Channel Direct Input
25 Volume Control
26 Surround Mode Selection
26 Digital Audio Playback
27 Surround Mode Chart
29 Tuner Operation
30 Tape Recording
30 Output Level Trim Adjustment
31 Advanced Features
31 Surround Amplifier Channel Assignment
31 Display Brightness
31 Turn-On Volume Level
31 Semi-OSD Settings
32 Full-OSD Time-Out Adjustment
33 Multiroom Operation
33 Multiroom Setup
33 Multiroom Operation
35 Programming the Remote
35 Programming the Remote
35 Direct Code Entry
35 Auto Search Method
35 Code Readout
35 Macro Programming
36 Programmed Device Functions
37 Volume Punch-Through
37 Channel Control Punch-Through
37 Transport Control Punch-Through
37 Reassigning Device Control Selectors
38 Resetting the Remote Memory
39 Function List
41 Setup Code Tables
52 Troubleshooting Guide
52 Processor Reset
53 Technical Specifications
See trademark acknowledgements on page 53.
2 TABLE OF CONTENTS
Typographical Conventions
In order to help you use this manual with the remote control, front-panel controls and rear-panel connections,
certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front-panel button, or rear-panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on-screen or on the front-panel
information display
1 – (number in a square) indicates a specific front-panel control
¡ – (number in a circle) indicates a rear-panel connection
a – (number in an oval) indicates a button or indicator on the remote
å
– (letter in an oval) indicates a button on the Zone II remote