Filter
Top Products
11
Setting up
Installing the Projector
Projection methods
* When suspending the projector from a ceiling,
change the configuration menu settings. p.34
When projecting from a ceiling
* If you place the projector off to the side, aim it
straight ahead (rather than at the center of the
screen), then use the horizontal lens shift dial
to center the image on the screen.
Configuration menu
Settings
Projection
Front
Front/Ceiling
Projection methods
TIP
You can rotate the EPSON logo plate around 180 degrees when suspending
the projector from a ceiling.
When one end of the plate is pressed, the
opposite end lifts up, so you can pull it out
slightly, turn it around and then push it back in.
If you are installing the projector on the ceiling, this projector should be installed by
qualified technicians using only approved mounting equipment. If installation work
is not carried out correctly, the projector could fall down. This may result in injury or
accidents. Contact your dealer to carry out the installation work.
If you use a ceiling mount and apply adhesives to the mount to prevent the screws
from loosening, or if you use lubricants or oils on the projector, the projector
housing may crack and the projector may fall from its ceiling mount. This could
cause serious injury to anyone under the mount and could damage the projector.
When installing or adjusting a ceiling mount, do not use adhesives to prevent the
screws from loosening and do not use oils or lubricants.
When projecting from directly in front When projecting from the side of
the screen
Do not use the projector in places where there is a lot of humidity or dust, near cooking
or heating appliances, or in places where it may come into contact with smoke or steam.
Do not use or store this projector outdoors for an extended length of time. Fire or electric
shock may result.
Clean the air filter at least once every 3 months.
Clean the air filter more frequently if using the projector in a dusty environment.
Do not use the projector on its side. This may cause malfunctions to occur.