Filter
Top Products
58
Basic operation
Displaying Amplifier Status (E-AMP DISP)
If a DSP Amp is connected, the status of the DSP amp will be
displayed.
Turn the [SEL] button to select E-AMP DISP.
The selected item will be highlighted.
Press the [SEL] button.
The E-AMP DISP mode is activated.
Turn the [SEL] button to select which amplifier
status you wish to display.
When the button is turned, the setting item changes in the
following order and the selected item is highlighted.
The deck will display all connected amps.
Press the [SEL] button.
The status of the selected amp will be displayed.
Turn the [SEL] button to change display content.
Each turn of the button allows you to toggle through status
categories as follows:
Press the [RTN] button.
At this time, other adjustments can also be made in display
adjustment mode.
Press the [DISP] or [RTN] button to exit display
adjustment mode.
[SEL] button
[DISP] button [RTN] button
E-AMP1 E-AMP2
E-AMP3
E-AMP4
E-AMP8 E-AMP7
E-AMP6
E-AMP5
TMP(˚F) TMP(˚C) CURRENT VOLTAGE
CD8445.book 58 ページ ２００４年１２月１３日 月曜日 午前１１時３０分