Filter
Top Products
30
ESN security operating procedure
How to operate the ESN (Memory Stick) security
How to record a security code
Check that the unit is in standby.
Press and hold the [FUNC] button, then button [6],
and hold both for more than one second.
A [SEC] message appears, in two seconds it will change to
[MS].
Insert the Memory Stick into the slot.
A [ - - - -] (security code input display) appears.
(Refer to "Listening to MG Memory Stick" on page 43 for
details on insertion of the Memory Stick.)
Input a security code by pressing buttons [1] to [4].
Enter a four-digit security code using digits 0 to 9, A to F. The
number (shown on the display) changes in ascending order
between 0 and 9, A and F each time the button is pressed.
Each button number (1 to 4) corresponds to each digit (first to
fourth) of the security code.
● If a Memory Stick has already been inserted, a [MS EJECT]
message appears. In this case, eject the Memory Stick and insert
again. (Refer to "Ejecting the Memory Stick" on page 94 for details
on ejection of the Memory Stick.)
● If the security is already activated, recording the security code
function is not available.
Buttons [1] to [4]
[FUNC] button
Button [6]
CD8445.book 30 ページ ２００４年１２月１３日 月曜日 午前１１時３０分