Eclipse - Fujitsu Ten CD8445 Stereo Receiver User Manual


 
111
How to operate the tuner
VIII
Changing the reception sensitivity for automatic
scanning
The deck lets you select the reception sensitivity to be used for automatic
scanning of stations. The two sensitivity modes available for this deck are
AUTO mode and DX mode.
Check that the deck is in standby mode.
Press and hold button [1], then the [FM AM] button, and
hold both for more than three seconds.
The mode switches between AUTO mode and DX mode each time
the buttons are pressed.
When an optional HD Radio tuner unit is connected, reception
sensitivity is set to the AUTO Mode. The DX Mode is unavailable.
(U.S.A. only)
AUTO Mode
During automatic scanning, the reception sensitivity switches
automatically to one of two levels. Initially the reception sensitivity
is set to the low level so that only stations with strong signals are
received. If no stations could be received, the reception sensitivity
is increased so that stations with weaker signals can also be
received.
DX Mode
Because the reception sensitivity for automatic scanning is set to
the high level from the start, even stations with weaker signals can
be received. (Signal crossover may result in some stations being
hard to hear.)
[FM AM] button
Button [1]
CD8445.book 111 ページ 2004年12月13日 月曜日 午前11時30分