Filter
Top Products
Network configuration
25
P 64 Digital Audio Matrix
Owner’s manual
4 Network configuration
4.1 Introduction
The P 64 Matrix Manager can be connected to a TCP/IP-network via the Ethernet interface at its
rear panel (see page 13). For further information on the principles of Ethernet and TCP/IP please
see the chapter Ethernet principles on page 33 in the appendix of this document.
The P 64 comes with the following network configurations from the factory:
An IP address must be unique, it must only be allocated to one single device (host) in a network.
In case a new Ethernet network is designed for the operation of the P 64, it is recommended to
retain the subnet mask and network ID which had been set at the factory. If the P 64 is integrated
in an existing Ethernet network, the network configuration of the P 64 must be adapted.
The preset IP address of the P 64 can be retained if and only if
• only a single P 64 with factory-set configuration is connected via Ethernet and
• the network ID 192.168.1 can be retained and
• no other devices have the Host-ID 100.
If at least one of these three conditions is not fulfilled, the preset IP address of the P 64 has to be
changed.
Parameter Value
IP address 192.168.1.100
Subnet mask 255.255.255.0
Gateway 192.168.1.1
DHCP deactivated