Filter
Top Products
95
ENGLISH
(4) “AUDIO SETUP” is selected
3
Use the
0
and
1
cursor buttons to select the “AUDIO
SETUP”, then press the ENTER button.
• DIGITAL OUT
Use this to select the digital output’s signal format.
• LPCM (44.1 kHz / 48 kHz)
Use this to set the digital audio output when playing
DVDs recorded in linear PCM audio.
To exit the audio setup mode
Use the
•
and
ª
cursor buttons to select “> NEXT DVD
MENU”, then press the ENTER button.
• The screen returns to as it was in step 2.
Use the
•
and
ª
cursor buttons to select the desired
setting, then press the ENTER button.
2
When “DIGITAL OUT” is selected.
• NORMAL (Factory default)
Make the selection when playing back in surround
playback a DVD that has been recorded with Dolby Digital
or DTS on this unit.
The Dolby Digital or DTS digital signal is also output from
the digital output jacks.
• PCM
DVDs that were recorded in Dolby Digital DTS are
converted to linear PCM 48 kHz/16 bit (2 channels). Make
the selection when making a digital recording.
To exit the digital out mode
Press the ENTER button, you can go back to the previous
screen.
DECISION : ENTER BUTTON
SELECT :
LPCM(44.1kHz/48kHz)
NORMAL
OFF
DIGITAL OUT
NEXT DVD MENU
AUDIO SETUP
AUDIO SETUP
DIGITAL OUT
NORMAL
PCM
SELECT :
DECISION : ENTER BUTTON
Remote control unit
Remote control unit
ENTER
Remote control unit
Remote control unit
ENTER
d
d
4
1
See page 88.
2