Denon ADV-M51 Speaker System User Manual


 
ENGLISH
45
3
Either turn the SURROUND/SELECT dial or press the
SURROUND button on the remote control unit to select the
surround mode.
SURROUND/ SELECT
PUSH
-
PARAM.
SURROUND
Main unit Remote control unit
The function switches as shown below.
The function only changes in the Æ direction when
operated from the remote control unit.
DOLBY VS STEREO ROCK ARENADIRECT
JAZZ CLUB DOLBY VSVIDEO GAME
4
Start playback on the selected component.
For operating instructions, refer to the components
manual.
The volume can be adjusted within the range 60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB.
5
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
M.VOLUME -20
VOLUME
Main unit
+
-
Remote control unit
The volume level is displayed
on the display.
•“DIG lights when digital signals are input properly. If DIG is
flashing, check whether the connections are proper and whether
the input components power is on.
Input mode display
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
One of these lights, depending on
the input signal.
Lit
Input signal display
DOLBY DIGITAL
DTS
PCM
Input mode when playing CD sources
When playing CDs containing recordings of live concerts, etc., in
the AUTO mode, the sound may be slightly broken at the
beginning. If this happens, switch to the PCM mode.
Input mode when playing DTS sources
If DTS-compatible CDs are played in the PCM mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to AUTO or DTS.
Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
MENU/SET
Main unit
SURROUND/ SELECT
PUSH
-
PARAM.
Main unit
STAT U S
Remote control unit
2 To check the currently playing program source, etc.
Press the MENU/SET button. Display STATUS then turn
the SURROUND/SELECT control.
To perform this operation on the remote control unit, press
the STATUS button.
The current program source and surround settings are shown
on the display each time the button is pressed or turned.
(When the function is set to DVD, the information is also
displayed on the TV screen.)