Denon ADV-M51 Speaker System User Manual


 
81
ENGLISH
(1) Setting the clock (12-hour display)
18
USING THE TIMER
1
Turn on the power.
2
Press the MENU/SET button to display Time.
MENU/SET
Main unit
If the time has not yet been set or if there has been a
power shortage, the time display flashes.
If the time has been set, the current time is displayed.
3
Press the MENU/SET button and hold it in for over 2 seconds.
The hours position flashes.
Time AM12:00
Adj AM12:00
MENU/SET
Main unit
Example: Setting the current time to 7:30 p.m.
6
Turn the SURROUND/SELECT knob to move to the minutes
position.
Adj PM 7:30
SURROUND/ SELECT
PUSH
-
PARAM.
Main unit
7
Press the MENU/SET button at the sound of a time signal,
etc.
The 30 in the minutes place stops flashing and the
current time is displayed.
Time PM 7:30
MENU/SET
Main unit
To check the current time when the regular display is displayed,
press the MENU/SET button once. The current time remains
displayed until some other operation is performed.
The time can be displayed by pressing the MENU/SET button
when the power is in the standby mode. (When this is done, the
set is no longer in the low power consumption standby mode.)
When pressed twice while the time is displayed, the display turns
off and the set is put back in the low power consumption standby
mode.
The current time can also be set when the power is in the standby
mode by pressing the MENU/SET button to display the time then
performing steps 3 to 7.
The clock runs by synchronizing with the power supply frequency.
The time may be off by 2 to 3 minutes per month. If so, reset the
time.
BAND
PHONES
VOLUME
O
N
/
S
TANDB
Y
DVD
SU
RR
OU
ND RE
C
EIVER
ADV-M51
TONE /SDB
FUNCTION
MENU/ SET
+
-
SURROUND /SELECT
PUSH
-
PARAM.
1
4,6
2,3,5,7
2 Timer and system operations are possible once the setup procedure has been completed.
4
Turn the SURROUND/SELECT knob to set the hours.
Adj PM 7:00
SURROUND/ SELECT
PUSH
-
PARAM.
Main unit
5
Press the MENU/SET button.
MENU/SET
Main unit
Adj PM 7:00
2 Be sure to set the current time. If the current time is not set, the timer standby indicator does not light and the timer will not function.
2 Be sure to preset the broadcast station before setting the timer. (See page 60.).
2 Everyday timer: The power is switched on and off (standby) once at the same time each day.
Once timer: The power is switched on and off (standby) at the specified time once only.
Sleep timer: The power can be set to turn off in 120 minutes, 90 minutes, or between 60 and 10 minutes in 10 minute steps.
2 If the times set for the everyday timer, once timer and sleep timer overlap, the sleep timer has priority. The once time has priority if the everyday
timer and once timer times overlap.
2 It is not possible to set the timer start and stop times to the same time.
ON / STANDBY
Main unit
Before setting the timer