Filter
Top Products
2. Input Setup
Use this procedure to select the input source and make the settings
related to playing input sources.
a ~ d HDMI In Assign
f ~ j Digital In Assign
k iPod Assign
l ~ A1 Component In Assign
A2 ~ A5 Video Convert
A6 Audio Delay
A7 EXT. IN Subwoofer Level
A8 Auto Preset Memory
A9 Parental Lock
S0 Edit Lock Code
a ~ d HDMI In Assign
Select HDMI connector to assign to this source.
[Input terminals]
HDMI1
HDMI2
HDMI3
[Assignable input sources]
DVD/HDP
＊1
TV/CBL
＊2
VCR
V.AUX
OFF
＊1 : “DVD” is displayed.
＊2 : “TV” is displayed.
Input terminals
a
HDMI1
s
HDMI2
d
HDMI3
Default setting DVD/HDP TV/CBL VCR
• When “System Setup” – “Speaker Setup” – “Surround Back
Speaker” setting (vpage 23) is set to “1spkr”, the surround back
speaker display is “SB”.
• Speakers set to “None” in the Speaker Configuration settings are
not displayed.
• When “Channel Level” is adjusted, the adjusted values are set for all
the surround modes.
Operating from the main remote control unit
Adjusting with the main remote control unit using the test tones is
only possible in the “Auto” mode and only effective in the STANDARD
mode. The adjusted levels for the different modes are automatically
stored in the memory.
GAdjusting using test tonesH
q Press [TEST].
Test tones are output from the various speakers.
w Use o p to adjust so that the volume is equal for all speakers.
e When the adjustments are completed, press [TEST].
For details on how to select, set and cancel settings for each menu, see “System setup operation” (vpage 22).
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
S3 Restore
After the Auto Setup measurements, it is possible to return those
settings to the Auto Setup measurement results after changing
the speaker settings (speaker configuration, distance, channel
level and crossover frequency) with ”System Setup” – “Speaker
Setup”.
It is not possible to return to Amp Assign settings with Restore.
After running Auto Setup, if the Amp Assign setting has changed,
return to the setting when Auto Setup was run.
Press o to start.
Test Tone Start
Press o to select “Yes”, then press o p to select “Auto” or
“Manual”.
Then press i. Out put the test tone.
Auto : Press o p to adjust the volume.
Manual : Press u i to select the speaker, then press o p to adjust
the volume.
When the adjustments are completed, press ENTER to finish the test
tone.
[Variable range]
–12dB
~
0dB
~
+12dB
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
23 Restore Yes<
[Display]
1.Sp 2.In 3.Op
W
Input Setup
W
1 HDMI1 DVD
W
2 HDMI2 TV
• With HDMI, the video and audio signals are transferred
simultaneously. (The HDMI audio signal is output from the monitor.)
At this time, set the input mode to “Auto”.
• The audio signals input from the analog, digital and EXT. IN connectors
are not output to the monitor.