Filter
Top Products
Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Recording on an External Device
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <ZONE2/REC SELECT> until “RECOUT”
appears on the display.
ZONE2 RECOUT
2
Turn <SOURCE SELECT> to choose the input source
to be recorded.
The “REC” indicator and the indicator for the selected source
light.
RECOUT SOURCE RECOUT TUNER RECOUT SIRIUS····
3
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
40).
4
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
Other Operations
• To cancel, press <ZONE2/REC SELECT>, then turn <SOURCE SELECT>
until “ZONE2 SOURCE” is displayed.
• Make a test recording before starting the actual recording.
• Sources selected with the REC OUT mode are output from ZONE2
as well.
• In the REC OUT mode, the remote control unit’s ZONE2 mode
buttons cannot be operated.
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Digital signals are not output from the REC OUT (CDR/TAPE and
VCR) connector.
Convenient Functions
1
Press <SELECT/ENTER> or [CH SELECT].
FL Vol.+ 1.5dB
2
Use ui, <SELECT/ENTER> or [CH SELECT] to select
the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
In the case of a sub woofer, reducing the volume when it is at
“–12 dB” will change the setting to OFF (none).
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
Playback
<SOURCE SELECT>
<SPEAKERS>
<INPUT MODE>
<SELECT/ENTER>, op
ui
<ZONE2 / REC SELECT>
QUICK SELECT<POWER>
uiop
[CH SELECT]
QUICK SELECT
uiop
[Front] [Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Other Operations and Functions