Filter
Top Products
1
Press <SURR. PARA> or [PARA].
Parameter is displayed.
2
Use ui to select which parameters to adjust.
Only those parameters which can be adjusted under the current
playback status are displayed.
3
Use o p to adjust the parameters.
Repeat steps 2 and 3 to set each parameter.
Adjusting the parameters
n To exit adjustment
• Press <SURR. PARA> or [PARA] during adjustment.
• If no adjustment is made for a period of about 5 seconds, the
adjustments made up that point are registered and the AVR-1709
returns to the original mode.
Surround Parameter
Adjust surround sound parameters.
The parameters (items) which can be adjusted differ
depending upon the following conditions.
• Whether an input signal is present (when playing) or not
(when stopped, etc.).
• The type of input signal
• The type of surround mode
For details of which parameters can be adjusted in each
surround mode, see “Surround Modes and Parameters”
(vpage 58, 59).
a Mode
s Cinema EQ
d D. Comp
f LFE
g Center Image
h Panorama
j Dimension
k Center Width
l Delay Time
A0 Effect Level
A1 Room Size
A2 SB CH OUT
A3 SUBWOOFER ATT.
A4 Subwoofer
A5 Tone Control
A6 Bass
A7 Treble
A8 MultEQ
A9 Dynamic EQ
S0 Dynamic Volume
S1 DV Setting
S2 RESTORER
S3 Night Mode
S4 Default
Parameter
uiop
MULTEQ
RESTORER
[NIGHT]
[DYNAMIC
VOLUME]
op
ui
<SURR. PARA>
<DYN VOL.>
MULTEQ
RESTORER
uiop
[STD]
[CINEMA]
[MUSIC]
[PARA]
[Front]
[Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH