Filter
Top Products
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
Q
8 FL 12ft
Q
15 SW 12ft
k ~ A5 Distance
Set distance from listening position to speakers.
Before making the settings, measure the distance from the
listening position to the different speakers.
Distance measurement
Select the speaker you want to set, then set the distance.
Set the value closest to the measured distance.
[Variable range]
0ft ~ 60ft
: Settable in units of 1 foot.
Default setting :
• FL / FR / C / SW ·············12 ft
• SL / SR / SBL / SBR ········10 ft
NOTE
Set the distance between the listening position and the various
speakers to no more than 20 ft.
A6 ~ S1 Crossover Frequency
Select crossover frequency from which subwoofer handles low
range signal.
Only the portion of the bass sound of the various speakers output
from the subwoofer that has a frequency below the frequency set
here is output.
Set this according to the low frequency reproduction capabilities of
the speakers you are using.
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz
:
Set the Crossover Frequency of all speakers as one.
Advanced
:
Set the Crossover Frequency separately for the different speakers.
q When “Cr.Over:Adv” is displayed, press ENTER or i.
w Press o p to set the crossover frequency of each speaker.
The preset speaker changes each time you press i.
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz
b In the case of “LFE”, there are 8 modes: 80Hz, 90Hz, 100Hz, 110Hz,
120Hz, 150Hz, 200Hz, 250Hz.
• If in the “Advanced” settings, “Subwoofer Mode Setup” (vpage
23) in the “System Setup” is set to “LFE (Normal)”, it is possible
to make this setting for speakers set to “Small” at “Speaker
Configuration”. If set to “LFE+Main”, this setting can be made
regardless of the speaker size.
• For speakers set to “Small”, sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• Always set the crossover frequency to “80Hz”. When using small
speakers, however, we recommend setting the crossover frequency
to a higher frequency.
S2 Test Tone
Adjust channel levels to obtain equal volume from all speakers.
Test Tone
Select test tone playback method.
[Selectable items]
Auto
: Automatically switch speaker from which test tone is
output.
Manual
: Manually switch speaker from which test tone is output.
For details on how to select, set and cancel settings for each menu, see “System setup operation” (vpage 22).
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
Q
16Cr.Over: 80Hz
Q
16Cr.Over:Adv
Q
17 Cr.F : 80Hz
F : Front, C : Center, S : Surround, SB : Surround Back, LFE : LFE are
displayed.
[Display]
1.Sp 2.In 3.Op
Q
Speaker Setup
Q
22 T.Tone Yes<
Q
T.Tone Auto >
Q
Test Tone On
Q
Auto-FL