Filter
Top Products
For buttons not explained here, see the page indicated in parentheses ( ).
q w e r t
yioQ0 u
Q1 Q2 Q3 Q4
Part Names and Functions
Front Panel
q Power operation button (ON/STANDBY) ·····························(56)
w Power indicator ·······································································(56)
e Power switch (hON jOFF) ··················································(56)
r Door
t QUICK SELECT buttons / indicators ······································(72)
y MASTER VOLUME control knob ············································(56)
u Master volume indicator
i Display
o Remote control sensor ·····························································(4)
Q0 SOURCE SELECT knob ···························································(43)
Q1 SOURCE button ·······································································(43)
Q2 TUNING PRESET button ·························································(57)
Q3 ZONE2/3/4 / REC SELECT button ····································(69, 83)
Q4 VIDEO SELECT button ····························································(45)
30°
30°
Approx. 7 m
or
(RC-1067)
(RC-1070)
NOTE
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
• The supplied batteries are only for verifying operation.
• When inserting the batteries, be sure to do so in the proper direction,
following the “q” and “w” marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
Operating Range of the Remote Control
Unit
Point the remote control unit at the remote sensor when operating it.
NOTE
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or infrared
light.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
AVPA1HDCIEU_0121.indd 7 2008/01/21 12:47:10