Filter
Top Products
NOTE
• Insert the AC plugs securely. Incomplete connections could cause noise.
• Only use the AC outlets to plug in audio devices. Do not use them as power supplies for hairdryers or
anything other than audio equipment. In addition, do not connect audio devices such as high electricity
consumption power amplifiers (e.g. POA-A1HDCI).
Wait until all connections have been completed before connecting the power cord.
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
(included)
Connection to the AC outlets
• These outlets supply power to external audio
devices.
• The power supplied from this outlets turns on and
off together with the set’s power switch.
• Audio equipment with a total power consumption
of 120 W (1 A) can be connected.
Connecting the Power Cord
Trigger output jacks
The power of an external device equipped with
a trigger input jack can be turned on and off in
association with operations on the AVP-A1HDCI.
For details, see GUI menu “Manual Setup” –
“Option Setup” – “Trigger Out 1”, “Trigger Out 2”,
“Trigger Out 3” or “Trigger Out 4” (vpage 41).
• Output level: 250 mA/12 V
Check the trigger input conditions of the
connected device.
External Controller
• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) and RF Remote
Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is possible.
The AVP-A1HDCI’s status information as well as iPod and Internet audio music files can be browsed
watching the RF Remote Controller’s display. For details, refer to the operating instructions of the
respective devices.
• When used in combination with an RF Remote Controller and RF Remote Receiver, make the settings at
GUI menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 41).
• When using the 2-way remote control unit, connect to the Port 1 RS-232C connector.
•
If GUI menu “Manual Setup” – “Option Setup” – “2Way Remote”is set to “Used”, you cannot use port
1 of the RS-232C connector for the external controller.
RS-232C connector
This connector is used for an external controller.
b If you use an external controller to operate
the unit via the RS-232C terminal, you must
confirm the following beforehand.
q Turn on the AVP-A1HDCI’s power.
w Turn off the AVP-A1HDCI’s power from the
external controller.
e AVP-A1HDCI enters the standby status.
Turning the Power On (vpage 56)
Once Connections are Completed
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
AVPA1HDCIEU_0121.indd 26 2008/01/21 12:48:03